Posted by Stick welding on January 28, 2014 at 17:49:31 from (96.53.210.246):
In Reply to: Bale Spear Sheared posted by 1130Leo on January 28, 2014 at 12:56:45:
Was the spear originally welded on or bolted on? I have seen some that are bolted on and the reason is because it is a high carbon steel like spring steel. Unless it was originally welded, trying to weld it could be a waste of time and money. Even it was originally welded, the chances of it holding for any length of time are very slim. If you did attempt to weld it, you'd need some very expensive specialty rods, a weed burner torch, a tempil stick so you can preheat it to about 600/650 deg's and then you'd have to slow cool it and possibly even stress relieve it. Then it might need to be re-tempered. Would be a lot easier to make a new spear. I'd make a spear out of heavy wall 2" pipe, not drill stem, and for extra strength stitch weld some tapered gussets down the length of the spear. The tapered gussets would also help to keep the bale from turning if you didn't have short spikes to stop it from turning. I think 5/16" or 3/8" plate would work good for the gussets. Pictures would help if you could post some.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
