Posted by charlie n on January 21, 2014 at 11:01:22 from (96.35.24.196):
In Reply to: planting alfalfa? posted by mmidlam on January 20, 2014 at 16:04:21:
I've done it both ways.
no till after Round Up burn down.This was an experiment.
full tillage and planted with a Brillion.By that I mean sub soil at least 20 inchs.mold board plow ,disk,harrow.and slick drum roll before the seeding.
I learned that from my dad.
I personally wouldn't frost seed but that's to each his own.Been doin this 45 years and have never had luck with it.I plant all my fields in late August or early September.
This was an actual sod farm for many years . I use a lot of the same principals in planting alfalfa that we used to grow grass and the results speak for there-self.
Do yourself a favor and have a complete soil annalist done.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.