Posted by JimEvans on January 16, 2014 at 18:02:44 from (66.185.0.197):
In Reply to: Small round bales posted by John Fulton on January 15, 2014 at 09:05:27:
We baled a lot of hay with a round baler. What was said about the hay quality is true. The round baler is more gentle and there are a lot more leaves in the bale than a square baler. Most of the time two windrows were raked together so there was only half as much driving as a square baler. You would run in 2nd or 3rd gear baling with a WD45. Even stopping every bale (and you stopped, not slowed down) you could bale circles around a square baler. However, if it doesn't want to work that day, you might only get 1 bale made in an afternoon. Some of the later balers did have a recirculator attachment on the feeder that you could run at a constant speed without stopping. The hay would just recirculate on the feeder while the bale was wrapping.
The were also pretty dangerous. Several people lost their lives or arms every year when the round balers were popular. The rubber roll would wear and not grab the twine correctly. The farmer would get off the tractor, leaving the PTO on and feed the twine by hand. When it grabbed, it would sometimes take their entire arm in. If they were lucky, someone was near by and could shut the tractor off and rescue them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ferguson TO-20 - by Staff. When the infamous "Handshake Agreement" between Henry Ford and Harry Ferguson fell by the wayside (that's a story in itself), Harry Ferguson quickly set up manufacturing plants for a United States version of his English TE-20. The TO-20 was relatively the same as the TE-20 except utilized some different casting materials and had a US-style electrical system. The TO-20 was a dead ringer for the Ford 9N and 2N models and they say that Ferguson did this on purpose when the Handshake Agreement wen
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
