Posted by jimg.allentown on January 15, 2014 at 04:19:32 from (98.115.105.174):
In Reply to: Interesting posted by Allan In NE on January 15, 2014 at 03:10:27:
I might remind you of a few things that you may have overlooked. The clutch plates you showed earlier looked like the low/reverse plates from a 4L60. Consider: Something caused them to burn as they did. Unless you repair the cause of the failure, your $11.80 repair will last a little while and fail again sooner than later. At a minimum, I would suggest that you do the following: 1) reseal the clutch piston 2) replace the gaskets and seals that you have disturbed (pump gasket, pan gasket, etc.). 3) replace the filter. 4) remove the valve body and check the seperator plate. This transmission uses steel check balls. They will beat their way through the plate in time and cause failures like yours.
If you should just replace the burned clutches and out it back together, you will most likely see why shops charge as much as they do, and why many folks will not bother with a repair - and just replace it with a remanufactured unit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
