Posted by N84 on January 05, 2014 at 18:11:55 from (68.255.3.208):
In Reply to: Ideal garage size posted by N84 on January 05, 2014 at 15:33:15:
If I could build a pole barn it would be 48' wide by 70' deep with 16' ceiling. The front door would be 18' wide by 14' tall on the right side of the builing. The entry door would be 4' from the left of the front garage door. The door on the left side toward the rear would be 12' wide and 14' tall. The other entry door would be 2'6" to the left of this garage door. The inside on the left side of the garage would have a 14' wide loft by 44' long. So the main front of the inside space would be 34' wide and 50' deep till you got to the next garage door. The space for the side garage would be 26' wide by 48' deep. In the loft on the main floor would be an office, half bath., utility sink, and utility room. The upstairs would have a full bath, living room, and kitchen. The exterior the only windows I would have would be on the garage doors. Of course Outside lights one above each garage door.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
