I"ve got a stack of McCord catalogs that I"ve been through so far but haven"t even found any EK numbers at all. I"ve found a few catalogs dating back to the early 60"s, but as far as the McCord"s go I"m stuck and have only seen as far back as the mid 80"s. That said, I know from looking through the ones I"ve got that they went through a change in the part numbers at least once. I"m figuring these numbers are earlier than the one"s I"ve got references. Do any of your catalogs, even the 3500 range ones, have dates on them to give me an better idea what year range to begin looking for? I"ve got probably two dozen boxes left to go through, over an above the two file cabinets I emptied tonight, so I"m sure I"ve got something somewhere. Having at least an approximate date would help me sort through the remainder of the manuals a lot faster, at least as far as finding these numbers is concerned. Thanks again for the help thus far, and anything else you can offer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Oil, Oil Filter and Air Breather - by Curtis Von Fange. In the preceding articles we discussed some of the various aspects of doing a comprehensive tune up. Hopefully some light was shed on why we do or don't do certain things pertaining to inspections and order of events when doing a tune up. Perhaps some useful reasons were given for why parts fail and what to do about preventing part failure in the future. All these tips will help us think and reason out a problem in order to make our tune up last and, hopefully, keep us from spending extra mone
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
