I used to be in the water well business and have installed many pumps. If the pump comes on and switches off with no change in the pressure in the house then the pump may be working ok. I would first check the pressure switch as sometimes they become corroded or the little pipe that connects the switch to the tank becomes partially plugged with sand or rust. If you have a pressure gauge at the tank, watch it while the pump recycles. If it pressures up quickly and drops quickly the tank may have lost it's air charge and you can fix that by follow the instructions posted by another.
If your pump is a 2 wire pump it will not run on 110 volts if one wire has an open circuit as each wire alternates as positive and ground. If the pump was trying to work on 110 volts it would not have enough power to pressure up your system.
If the pump pressure comes up and drops rapidly then you have a seious leak in the line from the pump to the tank. A temporary fix to this problem is to installl a check valve between the tank and the supply line. This will not fix the leak but will allow you to have water while you plan on how to fix it.
Last but not least, you may have a plugged or frozen line after the tank. Again you need to watch the pressure gauge to check this, or listen for the pump to recycle. If it slow to recycle with several faucets open then you may have a frozen line.
I hope this helps and the best of luck to you on this Christmas day.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
