Posted by PJH on December 23, 2013 at 11:21:34 from (50.40.252.80):
Christmas and fudge go together
Easy Microwave Fudge (Adjust times for your microwave)
Ingredients: 1 - 11 ˝ oz. package of chocolate chips
1 - 16 oz. can of creamy chocolate cake frosting
Put the chocolate chips in a microwavable dish and microwave for 90 seconds or until creamy.
Remove the melted chips and stir in the can of cake frosting.
Microwave for another 90 seconds.
Remove and add nuts, if desired.
Stir well and pour into an 8“ X 8” pan that‘s been lightly sprayed with Pam.
Cool well before cutting.
A couple of tips: Place a piece of wax paper, lightly sprayed with Pam, in the bottom of your 8 X 8 pan before pouring in the mixture. Cool it in the fridge. The fudge should lift right out of the pan when cool. Cut it on a cutting board, using a pizza cutter (roller).
For peanut butter fudge, substitute peanut butter chips and white cake frosting.
For white fudge, substitute white chips and cream cheese frosting. Watch closely when microwaving the white ingredients. They’re easy to scorch.
My favorite is semi sweet chips and dark chocolate frosting, but I’m kinda partial to the white fudge, too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
