Posted by Texasmark1 on December 23, 2013 at 06:15:25 from (172.242.14.143):
In Reply to: New Tractor posted by Small_Timer_IA on December 22, 2013 at 14:34:31:
I bought a 6530c Branson 4wd and FEL in '07. Made by Kukje in S. Korea. Really happy with it. 65 hp is a good size for what you mention as I am doing the same thing; in retirement and downsized. Big enough to do some serious work, but not too big and easy to get these old bones into and out of with the AC and heat, flat floor, tilt/telescoping steering wheel, shuttle shifter, air seat and all.
New tractors are really good on fuel. Mine burns .043 gal/hp/hr, so if working it hard at WOT that works out to about 2.8 gal per hour. Sure is a difference from my 6 cyl 2wd JD 4230.
My nearest dealer is 50 miles but the few parts I have needed, including a door to my cab, which I broke with a rock mowing, came in a few days via UPS from a warehouse in TX. Dealer said they had 6 in stock. Call them up, tell them what you want, use the debit card and presto. Don't need a nearby dealer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
