Posted by H. DeBruhl on December 19, 2013 at 14:14:39 from (74.250.172.40):
Hello,
Sorry this post is a bit long, I"m still trying to help my uncle figure out what�s up with his tractor!
I had posted a few weeks back about a Massey Harris 44 Diesel with an American Bosch PSB4A-80B pump not wanting to start and then constantly smoking when running. Motor is a full rebuild and general consensus was to recheck the pump timing.... Here is what we have done so far:
I had checked the timing prior to running the tractor the first time and thought the timing was correct. I must have been looking at the wrong tooth on the pump gear. I found the correct tooth and it was 180deg from where it should have been. I pulled the pump and corrected the timing. In the service manual I"m using it also states there is a pointer on the pump housing that should align with a mark on the pump drive. It is not exactly in line but very close when the gear mark and tooth line up. Tried starting the tractor and still no luck same issue as before. Upon further investigation I believe the overflow valve on the front of the pump has been messed with too. One of the possible problems for a hard to start tractor is for the overflow valve to be stuck open. I removed the small cap on top of the valve to only find a spring inside and a hole straight into the pump! Nothing to stop the fuel from flowing right back to the tank!! Can anyone tell me what should be there to stop the continuous fuel flow? Are there any exploded diagrams of the pump that I can reference? And finally is there anybody near Western North Carolina that can work on these pumps or is willing to come look at this tractor?
I"m not ready to through in the towel yet, but my uncle is ready to blow the tractor up!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
