Posted by notjustair on December 15, 2013 at 17:40:15 from (174.238.66.81):
I have an OLD apartment size gas stove that I used to use to can before I moved to the farm. It is perfect for it as the pot sits closer to the flame than the new fangled ones.
I only have LP here. I'm not sure whether orifices are standard or whether I would be able to get one. Is LP larger? Friend said she thought it was and she had drilled out an orifice when it was obsolete.
I haven't turned it to see if it has information on the back. I wouldn't be surprised if it was an old General Motors or something. I was just hoping I could drill it and someone knew the size bit.
Funny story. When I was a kid grandma wanted a new stove. We went to Great Bend and bought one. The kid that installed it had the wrong orifices in it. Grandma put in a roast and came back an hour later to a house full of smoke. She grabbed the Dutch oven and dropped it out the back door where it promptly burned an oval hole right throught the door mat. I knew dinner was in jeopardy when I got to the door and saw that hole burned in the rug.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.