Posted by Janicholson on December 14, 2013 at 20:55:53 from (74.60.94.18):
In Reply to: Tractor Flips Over posted by CGID on December 14, 2013 at 20:11:57:
Pulling things with a fixed drawbar (original) will almost always stop going up before total flip. a fast hitch farmall with a implement attached can't go over due to the rigidity of the connection. a properly attached 3 point system is also pretty imune from flipping. Most have the lift arms farther rearward than the wheel diameter, and limit upward travel physically. Unless the top link is a chain it too prevents flipping. There were tractors that were considered "Killers". They were eventually fixed with fenders that acted like wheelie bars. Fordson was one of the most villified. Any high attachment to the tractor near the axle front to back, and high from the ground (especially at or above the axle is very problematic. If you attach to a standard drawbar, and use it as designed there is no worry of that happening. I have been pulling as hard as the tractor can make power, and had the plow catch rocks and roots that stopped it cold. It can get the front up, but it is controllable. first time operators should be driving doing light load operations and practice enough control movement and pedal operations that it is instinctive to get it stopped. You will find your clutch foot hovering near pedal contact for the first 50 hours of operation no matter what. as the tractor begins to bog, you will touch the pedal (but not push on it) in anticipation of such a move. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
