Posted by Leroy on December 10, 2013 at 05:58:13 from (74.126.42.240):
In Reply to: Frankentractors posted by DeltaRed on December 09, 2013 at 21:34:59:
Steve, what I would like to know is how did they put that front end on? The A had a sollid 1 piece casting from the gear at the top to the bearing at the bottom between the wheels and you cut that bottom off then there would be no way to hold the shaft in place. Now an AN the front casting was short with a lower bearing at frame height, (same as tha AW) but the vertical shaft was still full length but with a yoke for the front wheel. It I can see if it was a AN that by cutting that wheel yoke off it could be done but not on an A. The AW would have been an easy conversion just removing the wide front and replacing but why would any one do that as the AW axle would have been as good as the IH axle. Later A had a 2 piece pedistal but they were not made for your model and do not know if the whole pedistal could be replaced with newer style. Just trying to figure it out. The F12 is easy to figure out but not that front end.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I�m handing him tools and he says, "give me that..." and I�ve already got it in his hand or "hand me that....."and I�ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
