John in La said: (quoted from post at 22:33:35 12/07/13) You have contradicting terms in your post so answer a few questions.
You say "hauling my own stuff" so that only means you are a private carrier. They still need DOT #'s.
Then you say "I'm not in business".
How do you mean this. "I am not in the trucking business" OR "I am not a business and only haul my camper; 4 wheeler; around".
The rules are.
You are a business AND
You can weigh 10,001 lbs AND
You cross state lines OR you do not cross state lines but live in one of these 29 states.
Alabama, Alaska, Arizona, Colorado, Connecticut, Florida, Georgia, Iowa, Kansas, Kentucky, Maine, Maryland, Michigan, Minnesota, Missouri, Montana, Nebraska, New York, Ohio, Oklahoma, Oregon, South Carolina, Tennessee, Texas, Utah, Washington, West Virginia, Wisconsin, and Wyoming.
If you can answer yes to these 3 questions you need a DOT #.
Remember farms; lawn service; or seller is a business.
Now some of the 29 states above may exempt different business that only travel intrastate (in state) from some or all of the rules. You need to ask your state that. This could be the farmer exemption rrlund is talking about for his state.
I should have clarified that my comment was for two different items. First was the CDL that I have for working for someone else. Second is for my pickup and goose neck which I haul my own tractors with. I'm not in business, and am hauling my own tractors, and can go over 10001 pounds. Now, I can give you the phone number to Washington DC DOT that I called. I knew I would get an argument out of it, that's way I called them to start with.
This post was edited by J.Wondergem at 15:59:05 12/08/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
