I have a Neilson unit I bought for $70 when I became a McCulloch dealer in 1968. Still going strong.
Does a great job, and contrary to what critics say, if this type of grinder is adjusted properly, they don't remove any more than is necessary to sharpen the chain.
Now, the downside to my Neilson is they apparently aren't made anymore. My Neilson originally used wheels of tree different thicknesses for different size chains. Plus the Neilson wheels have a 3/8" bore. I've worn out all of the Neilson wheels I bought while I could still get them, and the only ones I've been able to find lately are 1/8" thick with a 7/8" bore.
I machined an adapter to use the 7/8" bore wheels on my Neilson grinder, but being limited to using a 1/8" thick wheel limits the versatility of the grinder.
If anyone knows where I can get different thicknesses of wheels, I'm all ears.
To answer your question, I think if you buy any one of the popular bench mount grinders and get used to using it, you'll be happy with it.
I've played with HF's grinders that are on display, and compared to my old Neilson, I wasn't impressed, but that might just be what I'm used to.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.