NO!Dont use a tractor to pull it apart!You cant control finely enough and the tractor hydralics will settle. You could/will tear up something.I commonly split on dirt.You need to get a proper splitting stand.Make one as I did. Dont try to save(money)by useing a floor jack as some do.That is an accident/disaster/tragedy waiting to happen.Block/secure the rear half.Placelong 2x6,8,10 etc under tractor.Even 1/2 plywood will work if dirt floor is aomewhat hard.Lay 3 or 4 4x8 sheets crossways on the floor and then park the tractor on them(You now have a 'hard' floor).Put stand on front and rool the front away useing the wood as a 'hard' smooth surface.Kinda a PIA,but it works.And Ive done up to 125 horse tractors that way.I some times use a comealong to help to slide them together(something you can feel).Good luck. If you need to call,pleaase do. cell(970)417-1178 Steve
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.