If I understand correctly, you want to combine the two feeds into one parallell feed, right?
By code, you cannot parallel #10 wires, so if you did it would not likely pass an inspection. #10 is good for 30 amps, so in theory, you would have 60 amps of load capacity, however, the code doesn't say what it would be, because the code doesnt allow it.
Another option may be to put in two small subpanels, each with a 240V 30A feed. Around here you can buy 6 circuit subpanels for less than $20, or a slightly larger 12 or 20 circuit for around $50. In the end, you would wind up with the same current carrying capcity, and it would be a code compliant install. Don't forget to separate neutrals and grounds in subpanels, and do not bond the neutral and ground together!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Collection of a Lifetime - by Sherry Schaefer. The larest gathering of orphan tractors ever assembled by one collector will be auctioned off on May 15 in Rock Island, IL. Ed Spiess was a well known tractor buff who spent most of his time dreaming of rare and unknown tractors. His background as an agricultural engineer sparked his interest in the unique attributes of the models built from 1939-1959.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
