Posted by buickanddeere on November 09, 2013 at 09:35:31 from (184.151.61.160):
In Reply to: Lectrical question posted by JMOR on November 09, 2013 at 05:58:11:
Quoting Removed, click Modern View to see
I don't know where you are getting neutral dots from.
That is a ground wire from the neutral bar to the ground rod. Not a neutral wire.
A neutral wire carries current and has white insulation on it. The neutral is connected to the Center tap of a transformer. The neutral wire carries the same current as the line on a 120,277 or 347 circuit in North America. The neutral also carries the imbalance between L1 and L2 back to the Center tap of the service transformer on a single phase transformer. The neutral carries the imbalance between L1,L2 and L3 back to the transformer Center tap on three phase .
The bare ground wire running from ground rod to neutral bar is not supposed to carry any neutral current.
Sorry but your lack of knowledge doesn't let you see the difference. You are the type of person that runs 120V device neutral to chassis on 240V equipment where there is only two insulated line conductors and a bare ground. Then wonder why livestock are spooked.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
