Posted by Rick Kr on November 04, 2013 at 19:37:28 from (198.105.227.101):
In Reply to: snow plow A frame posted by Jake in NY on November 04, 2013 at 17:41:23:
Jake, Not sure if this is much help. Picked up a Meyer blade for scrap. Cylinders were junk. Torched off a few brackets, then welded up a couple of supports to slide over/under the bucket. Chain it down and go. I didn't care if it pivoted at that time. Now I have a quickattach on this tractor and may add a cylinder out there as soon as I get the hydraulics finished.
You can still push a lot of snow with the blade straight.
Your idea sounds ok, a QA plate is around $150. But if you are going to make it swivel you will still need a little frame in front of it. I assume the new tractor already has a QA on the loader.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractors and the City Boy - by Ken. A few years back I came to the conclusion that city life wasn�t for me. The houses so close together you could hear the neighbors fight, traffic so heavy speed limit signs meant nothing. So I started looking for the ultimate country setting. After many months I found the perfect place, off the beaten path, up a private � mile drive, old stone house which has stood the test of time, out buildings which haven�t stood the test of time, trees, birds, rabbits, and snakes. This is the place! Bought
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
