Posted by rankrank1 on November 03, 2013 at 19:00:47 from (198.228.228.150):
In Reply to: Well went dry posted by bigboreG on November 03, 2013 at 18:09:39:
Based on your added responses it sounds like you have a rather shallow well - of which I know very little about when it comes to repairing shallow wells.
On deeper wells (80' to 100' type and pitless in type): I do know a quality well driller can sometimes clean and rehabilitate an old well before simply drilling a new one. Neighbor near me was having issues with their pitless well and the driller cleaned the well and did the "last resort" trick where the driller takes the drilling rig truck and cuts a slot in in the existing well casing pipe every few feet near the bottom which allows the casing to fill the well from alternate source veins. (I believe that you have to have a steel casing way down in the ground instead of plastic for this "last resort" trick to work since pastic might shatter when they try to slot it with their wedge tool - but do not hold me to it).
Still cost a few hundred dollars to have this done but much cheaper than having an entirely new well drilled and plumbed up in comparison which could be in the thousands of dollars depending on depth and distance from house.
This post was edited by rankrank1 at 19:10:21 11/03/13 5 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tinker�s Guide to Manifold Repairs - by Curtis Von Fange. A common characteristic of keeping older equipment is that some parts to make repairs can be extremely difficult to locate. For example, finding a replacement for a cracked intake or exhaust manifold on a unique tractor or odd brand can be a frustrating and downright impossible mission. So, what is an alternative solution to scraping out that �one of a kind� piece of history? First, decide if you are one to try a repair yourself or have someone else do it. If you are uncomfortable about
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
