Posted by John B. on November 03, 2013 at 18:16:44 from (50.40.67.67):
In Reply to: IH 404 posted by bigdiesel on November 03, 2013 at 14:36:09:
A buddy of mine bought an IH 444 this spring. He gave $4500 with a loader on it but no power steering. It didn't have much engine oil pressure but he used it up until last week. We took the pan off and pulled out the rod bearings all looked good. Then we pulled the oil pump out and saw that the bottom plate on the pump was warped and parts of the gasket were missing. The pressure relief valve spring must of pushed the plate down over the years and created a gap between the plate and pump housing. A new plate is $128. Got one on order. The plate that was on there looks like pot metal or aluminum and the rest of the pump cast steel. We did also replace the rod and main bearings while we were in there. Waiting on the pump plate now. Those are nice little tractors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
