Posted by jdemaris on October 26, 2013 at 05:41:32 from (70.215.10.67):
In Reply to: John Deere 1010C posted by Robert Radcliffe on October 25, 2013 at 18:52:30:
As the other guy said - there is NO engine clutch. If there was - sticking or dragging would not cause your problem anyway. It's a powershift type reverser with hydraulic powered clutches. The term "powershift" denoting the ability to shift on the go, under power, without touching the clutch pedal.
Your's is dragging enough to make it hard to get the gear trans into gear. Try idling engine all the way down to the lowest speed and then try to ease into a forward gear. If it clashes too much try easing into a reverse gear. A little clash is normal but it should ease in with the engine at idle speed.
What happens when you are in let's say 1st gear in forward and you push in the clutch? Does it stop with the engine running freely, or does it want to keep going and when you hit the brakes, the engine labors? If the latter, the clutch discs in the reverser are warped, or the center-bearing is burned up (very common problem). More common in 350s, but happens in the 1010s as well. The reverser has a tiny cup and cone bearing assembly between the input shaft and output shaft. It takes a real beating when using the crawler hard in hydraulic reverse. Later on, in mid-range 350s it got upgraded and enlarged.
And yeah, you also have to make sure the clutch linkage is working.
If it's dragging, put a gauge in the clutch port (under your left foot) and look for 120-130 PSI when the clutch is up and 0 PSI when it's down. It's the same thread as a grease-gun hose. So a 200 PSI gauge hooked to a grease-gun hose is all you need.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning Up Your Tractor: The Battery - by Curtis Von Fange. Buried somewhere beneath the sheetmetal, under the gas tank, or stuffed in front of the radiator is the battery. This elusive and neglected component of the tractor is the hardest to get to when it is dead and in need of a jump. But usually, the storage battery is a storehouse of electrical energy waiting to be released a the flick of a switch. A few maintenance tips and periodic cleaning will keep it charged for the duration of its life span. The battery is made up of a number of lead bas
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
