I had a large oak fall on an outbuilding, roofed just 2 years ago. No place to get my large loader in, and I wanted to avoid damage to the roof under the trunk. A contractor friend looked, scratched his head, and gave me the number of his favorite tree service.
The tree guy came out and said no problem, he'd have a large crane out on Monday. Up my driveway to the top of the mountain? Might want to get the crane guy out first. He came out Sunday evening and said no way would he risk his expensive machine for such a small job. I agreed with him.
After that the tree guy was out of ideas, but eager to have his crew help me if I could figure it out. Yeah, right.
I don't climb, but I put a wire rope 60 feet up another tree, over the fallen tree, to one uphill where I didn't have to go so high to set a snatch block. Tractor supplied tension on the wire rope to lift sections off the roof. A comealong doubler running on the wire rope allowed us to pull the sections off and lower them next to the building.
The tree came off with no further damage. The guy who helped me will heat his house for a winter. Wet weather finally left and I can get in to replace the shattered framing. Even most of the copper pans can be reinstalled. I like oak lumber, probably why the tree didn't fall farther. Branches hanging out the other side of the ridge were 40 feet long.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.