Looks as if you will be putting New Shins on it right away..
That is a nice looking plow of "average" weight..heavier than the plows made for the 8N/9N but not as heavy as the ones made with the heavy box-beam..
Do put the needed new pieces on AND clean the moldboards and cover-boards up before you attempt to use it..(then, KEEP it from re-rusting).
An Angle-Grinder with a Thin "Cut-off" wheel is your friend, for this job.. Hold it at about a 30 degree angle and it will only remove the rusty surface and not even scratch the steel..! Use a Mask and safety glasses...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Seeing an Old Friend - by Joe Evans. Dad had a concrete contracting business starting in 1960. One of his first pieces of equipment was a Ferguson TO-35 with a Davis loader. Dad replaced the TO-35 with a MF 202 Workbull, essentially an industrialized Ferguson 35 I am told. Dad bought the 202 new in 1962, and I recall quite clearly going to the dealer with him to sign for it.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.