Posted by fixerupper on October 08, 2013 at 10:27:24 from (100.42.83.15):
In Reply to: Garage floor paint posted by Hotflashjr on October 08, 2013 at 05:37:15:
Quoting Removed, click Modern View to seeI used it three years ago and everything the other guys have said is true. Epoxy paint is tough as nails but it's very fussy about surface contamination. The garage floor I put it on was 40 years old and pitted from salt drippage off of the cars. Added to that was oil under where the car engines were.
Here's how I did it, this was in the middle of the summer. First I scrubbed it with a degreaser, then came the 4000 PSI hot water power washer with a rotary nozzle. I kept the nozzle a couple inches from the floor and I took lots of time. Took me at least two hours to do a 20X30 floor. Then I degreased and flushed again. Then I used a cement patching product to trowel over the pits and pocs in the floor. The next day I washed it with the acid to etch the old cement. After that it was sit and wait for it to dry and that might be several days. The instructions tell you to tape a sheet of plastic down in one spot. Next morning you pull up the plastic. If it's damp on the underside the floor is too wet.
The paint I put down popped up in a couple of very small places (maybe 2 square inches each a couple of days after it dried. The floor must have been too damp in those two places. One person told me the paint will come off where the car tires sit but that hasn't happened to me. If you do use the glitter a hand held grass seeder might do a more even job than throwing them out by hand. Read the instructions. Good luck and let us know how it turned out. Remember-CLEAN AND DRY! When you use epoxy you should not scrimp on the preparation. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
