Posted by Janicholson on October 07, 2013 at 19:52:34 from (74.60.94.18):
In Reply to: Buzz Saw, What Do I Do? posted by Bryce Frazier on October 07, 2013 at 13:32:25:
Put at least 3 "T" fence posts in the ground at a 45 degree angle. they should go in at least 2 feet in clay, or 3 feet in softer earth. These should be placed so they will hold against movement toward the tractor, and upward movement from the belt pulling on the pulleys. An additional stake should be placed in front of the frame to prevent the frame from turning toward the belt side. Decide where to place the saw that will allow it to stay put while using it, and will not have the stakes becoming an issue later (or pull them out when done for the season) Make sure the platform that allows the logs to enter the blade is free to move and counter balanced to make it easy to control. Springs may be weak or missing. It should be easy to position logs so that safe hand and arm motion can be used. A guard from a curved steel strap that prevents the back side and top of the blade from being easily touched is a great idea. Finding an old farmer to assist with the project might also gain you a great friend and possibly a welder to assist in the setup. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
