Posted by gbs on October 02, 2013 at 19:33:40 from (64.234.38.41):
In Reply to: Offset Disc posted by UP Oliver on October 02, 2013 at 13:31:18:
there are a lot of variables blade sizes ,spacing ,section angle adjustable or not,weight of the disc, depth of cut,type of dirt ect,daddy pulled a 20 blade bushhog with an m farmall 2 gear most of the time of coarse it was set to where the tractor could pull it, more than one person stopped by the field to watch it in action,use to disc for a neighbor he had a 28 blade taylor-way that was all a strong 1256 ih wanted,uncle had one he cut new ground with, if I remember correct was a 16 blade, wide spaced blades that adjusted from the tongue no wheels it would stall and old model 7 cat in full section in the right dirt
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
