You said your new voltage regulator indicates used with positive ground. Therefore you attach the positive terminal of the battery to the frame of the tractor. Before you start the engine, polarize the generator by momentarily touch a jumper wire from the battery terminal of regulator to the generator terminal of regulator. (some regulators are marked armature instead of generator).
The reason you polarize is so when generator start charging and the cut out relay in the regulator closes, you have a positive charge on one set of points and negative on the other point. If the points close with like polarity, the points will severely arc, probably damaging them or maybe even sticking them together.
Few regulators now days are marked for one polarity so I am going to assume you have a better quality regulator as the ones that are marked should have different metals on each point to minimize arcing and electrical wear so to speak on the points.
A good regulated 6 volt system with good full charge battery should regulate right close to 7.2 volts. If you have working lights, turn them on before starting engine and if ammeter reads discharge as it should the ammeter is hooked correctly. If reads charge you will need to reverse the wires on ammeter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.