Posted by MarkB_MI on September 28, 2013 at 02:27:55 from (75.219.17.191):
In Reply to: Gas-additive question posted by Kirk Affeldt on September 27, 2013 at 18:33:37:
You're starting from a flawed premise, that there's something seriously wrong with today's gas. Those tractors were not designed to run on high-octane gas; if you want to use it, fine, but they don't need it. It's true that almost all gas sold today has ethanol in it, but there's nothing you can add to fuel to take it out, so stop worrying about it. If you have a supplier who claims they are selling ethanol-free gas, I sure wouldn't take them at their word. You can test for ethanol in your fuel with a mayonnaise jar and a grease pencil, google it.
In my opinion, most fuel-related problems stem less from the gasoline itself and more from the infrequent use of the equipment itself. In most of the country, winter-grade fuel is more volatile than summer fuel, so it you have a tractor that doesn't get much use, filling it up in late summer is a good idea. Refineries switch to winter fuel around October 1st.
I admit I put a little Marvel Mystery Oil in my tractor's fuel. I've had problems with valves sticking when it sits for a while; that seems to have cleared up after I started using the snake oil.
As for "Stabil for Ethanol", does anyone really believe it is significantly different from plain oil Stabil?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.