Posted by old on September 13, 2013 at 18:35:52 from (209.86.226.27):
In Reply to: Re: 8n ford tractor posted by ronnie wheat on September 13, 2013 at 18:21:35:
2 wire never heard of one unless it is wired wrong out your not counting the wires right as in if a Delco 10SI you have the plug that has 2 wires and the #2 wire goes to the big charge stud the #1 goes to the ignition and then the big charge stud goes to the amp gauge. I the #2 is not hooked up that can cause over charging which can cause problems. By the way no such thing as a coil with the resister built in they are just a coil wired for 12 volts and do not have a resister. Sounds like you have cheap points or set wrong. Side mount you set at 0.025
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Weldin Basics, Part 3 - by Curtis von Fange. Oxy-acetylene Welding - Part One In our series on welding we have taken a brief look at AC and DC arc welding along with basic techniques and safety equipment required for safe usage. Since our premise is to cover welding types that might best be used on a farm environment we have kept our overview purposefully simple and general. The second type of welding that this observer finds quite useful in
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
