Posted by Leroy on August 26, 2013 at 06:46:09 from (74.126.42.240):
In Reply to: Re: Hay Rake posted by chevytaHOE5674 on August 25, 2013 at 19:38:42:
If they would have raised the front axle to normal pull type or steel wheel rakes it would have been a good rake with the gear speed between the wheels and axle instead of putting it after the gear box. If I could figure out a way to make that conversion then the one I have here now and figuring to part out and the one I redid last year for him that hasen't sold because of that axle I would do it to both. I have a place to go with any and all steel wheel rakes in working condition as long as styled for as to be able to work and that low axle was not styled to work. It is only good for raking just a flat mower swath but not for putting 2 together or rolling a swath to dry out. That one last year was one of a dozen I delievered and This year have lost count how many I have done over.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
