Posted by Diydave on August 25, 2013 at 16:45:19 from (96.244.163.21):
In Reply to: BROKEN OFF BOLT posted by One Denny on August 25, 2013 at 11:21:38:
First thing I would do id to center punch it as close to center, as possible, then heat with a propane torch, to about 250 F, and apply a bees wax candle to the area around the bolt. The wax will wick up (or down) and lube the threads. Next I would go with left hand drill bits, drill about a 1/4 " hole at least 1/2" deep, then hammer in a pipe style easy out ( comes in a set sized from A-Z) Attach a small air impact, and give it a couple taps. If the easy out strips out, you re-drill next size up, and try again. generally the bigger bolts come out easier than the smaller ones, if that is of any consolation, to you!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Antique Tractors a Passing Fad? - by Tractor Talk Forum Participants. A Talk of the Town article - Do you see antique tractors going out like a fad? Value has come down this winter. An example is the Ford Model A and T cars that went through this in years ago, along with the hit & miss engine. Will the younger generation move on to something else? Will it be harder to sell them and what models will be affected? Could we see the value crash on our rusty relics?
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.