Posted by JD Seller on August 25, 2013 at 11:54:32 from (208.126.196.144):
In Reply to: BROKEN OFF BOLT posted by One Denny on August 25, 2013 at 11:21:38:
If you do not have a good set of easy outs then just center drill the bolt. Drill the bolt until the sides are real thin. I then take a chisel I made out of a 1/4 inch pin punch. This chisel is half round on one side so you can pick the bolt out of the threads easier with it.
Trick to do. If you missed the center of the bolt. When you get the hole big enough to get a die grinder rotary cutter into the hole. I have a set of carbide burrs. I take a small straight one and cut the bolt away. You can get real close to the threads this way.
There is not a big secret way to get a broke bolt out. It just takes time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.