Posted by JD Seller on August 22, 2013 at 07:29:55 from (208.126.196.144):
In Reply to: 3 point quick hitch: posted by Dick on August 21, 2013 at 22:08:55:
You need to measure your implements first. The smaller CAT I and II implements do not always have the exact ASAE dimensions on the hitch. This is needed some times to make the implement work correctly. An example of this is a three point moldbaord plow. The "crank" front hitch would not work in a quick hitch very well.
I have found that the larger CAT III stuff usually has the hitches built to the ASAE standard.
So my bigger tractors have quick hitches on them the smaller ones do not.
There are two other things about quick hitches I do not like. 1) The move the implement back further from the tractor. That can cause issues with control and PTO length. 2) The "HOOK" on the back of a quick hitch does not fit the three points pins as tight as your lift arm balls will. So you have additional sloop in the hitch. On implements like a blade that is a PIA.
If you are using smaller implement and are changing allot then there is a tri-angle type quick hitch that does work well. I have sold them to land scape guys and a few golf courses. In these applications they maybe changing attachments many times in just one day. The tri-angle hitches have a "female" attachment/adapter that you put on the implement, you leave it on the implement. The attaching points on this "adapter" are adjustable. So you can make it fit a lot of different hitch patterns. Then you have the hitch that fits the tractor three point. These work very well. You do not even have to be perfectly straight and they will hitch. The disadvantage of them is cost. You need the tractor hitch and then several implements adapters. I think this hitch is more common in Europe that in North America.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
