Posted by Mark - IN. on August 20, 2013 at 17:00:31 from (98.215.76.204):
In Reply to: Interior barn lights posted by Thartiga on August 19, 2013 at 17:06:02:
Can't get mercury vapor anymore, but the replacement is metal hallide and in a barn your size, three evenly spaced will give you more light than you will ever need, especially if you have a concrete floor. My small barn is 60'x40' and I put up two, seperate switches because don't always need both, and often don't. Two do fine, but I have a brother that is legally blind, but can see a little. He says that if was his barn with his eyes, would have gone a third...evenly spaced, but two was ok for him.
I got the idea from my brother because his neighbor did the same, so I tried it. Take a couple minutes to warm up like flourecent, but once they do, bouncing off of the concrete floor, right down the center from front to back breaking the length up into thirds (two bulbs, evenly spaced into three sections) is a ton of light, 300 watt bulbs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
