Posted by NCWayne on August 19, 2013 at 20:14:36 from (98.21.228.82):
Thanks for the replies to my post the other day about the oil leaking into the engine. I finally got the coolant system cleaned out again over the weekend and got a chance to check the oil cooler again. I had done it before with compressed air and dunked in water, and saw absolutely no bubbles. This time I did it on the engine with it running. What I did was to disconnect the coolant lines running to it and block them off. Then I fired up the engine and let it run for nearly 10 minutes with no leaks to be seen. With the engine warm I decided to go ahead hit the load start button and actually let the compressor come to the design pressure and put at least a little load in it...again, no leaks. So, I took it a step further and opened one of the valves so it could start blowing and put a real load on it. It went for maybe 5 minutes like that before I started seeing oil coming out of the open coolant ports on the cooler.
I don't know what part of the cooler is leaking but it didn't spill a drop until the engine hit between 150 and 160 degrees, and was put under a load. So, with the problem now identified without a doubt, there will be a new one going on tomorrow and the thing will finally be out of my hair.
Thanks again for the replies to my previous post. Wayne
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
