Posted by John_PA on August 16, 2013 at 19:18:54 from (72.95.159.156):
In Reply to: weed wacker posted by Jim/Pa on August 14, 2013 at 16:57:01:
I have the pivotrim.
Do you want my honest opinion, or a really good story?
I guess it all depends on what you are cutting, and what it against what you are cutting. The pivotrim, with all 4 strings in it really holds the weedwhacker back. Hard on the centrifugal clutch. If you touch high tensile fence with it a few times, it is done. The line breaks at the holder and leaves the stub wedged in the holes and it is a pain to get out.
The line pieces they give you "free" aren't worth a pint of wiz. The shipping and handling charges are more than what the replacement line is worth.
I go with Oregon gatorline now, with the steel core. It lasts a _little_ bit longer, but still not good. The cutter works faster and easier on the powerhead clutch if you use just 2 lines, but they break pretty fast. Of course, I am smacking high tensile an barbed wire and iron weed and thistle. The promo of them cutting through plywood is pure fiction. I could not replicate their demonstration if I tried, guaranteed.
The good old bump advance is still the way to go, if you ask me. I take the shield off the end, so that tall weeds and grass don't bind up the head as much.
I have not tried the new yellow bladed extreme cutting head that they advertise, but I would assume on encounter with steel or something sharp and hard would be the end of those blades.
just my 2 cents... your mileage may vary
+1 on the DR walk behind. It truly is a beast. I like it better, but, it will rip vinyl siding of the house in a flash if you loose concentration for a split second.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
