Posted by Mark - IN. on August 14, 2013 at 20:55:35 from (98.215.76.204):
In Reply to: Woods mower question posted by notjustair on August 14, 2013 at 20:02:56:
Its not just a matter of reversing the direction of the belts because the threads on the pulley shafts are reversed as well, which means the nuts are reversed too. So, you reverse the direction of the belt which causes the blades from the L to spin correctly on the R, or vica-versa, but the weight of the blades spinning in the opposite direction of the nuts holding them on, will work to loosen the nuts. What a mess that will make if the nuts come off at speed, and then the blades as well. I once questioned it when ordered new blades for my L59 that were R59 (opposite spin). Setting on a shelf in one of the barns is a perfectly good, never used set of blades that I cannot ever use. I ended up buying another correct set after loosing my receipt and the counter guy that sold them to me wasn't there when I tried to return the non-stock ordered set of blades. Reversing direction, flipping blades? Nope, will not work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
