Posted by old fashioned farmer on August 13, 2013 at 17:00:30 from (99.148.199.11):
Howdy,
Back to workin on the 720 again finally. I had an issue with the flywheel walking on it. You all helped me to realize I had the taper lock flywheel. I found instructions for putting one of those monsters back on and finally had a chance to do it today. I got it on tight with good endplay. When I started up the tractor the flywheel scraped against a shield that sits behind it. Now, this wouldn't be an issue if it were just a scraping. I have bent things sometimes that might cause it. The problem is that you can turn the flywheel over and not hear anything for a time and then feel and hear it scrape. It almost seems like the flywheel is wobbling. It feels that way too somewhat when the tractor is running. It doesn't shake horribly but it is noticeable and feels different than the usual vibration from it being a two banger. Anyone have thoughts about the flywheel? Appreciate the help. God bless.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
