Posted by Hal/ Eastern WA on August 13, 2013 at 11:47:13 from (97.115.139.142):
In Reply to: crankshaft posted by 4020deereboy on August 12, 2013 at 22:53:03:
Maybe, depending on where the break is and how bad it is. And maybe if it is super rare. I would be talking to someone with experience in welding and remachining cranks to see what they thought about your individual problem. My guess is that it would be expensive and technical. And the result might not be as strong as an original crankshaft.
Unless it was a lot less expensive to have a crankshaft welded, I would start looking for a replacement shaft that could be used as-is or which could be machined for the next undersize. I also would try to figure out what made the original crankshaft break. I have had bearings spin, which damaged crankshafts a couple of times, but I have never encountered a broken crank in my 50+ years of tinkering. Maybe I have just been lucky...good luck to you!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.