Posted by gene bender on July 31, 2013 at 11:29:48 from (67.55.227.26):
In Reply to: Re: sand blaster posted by Josh in Pa on July 31, 2013 at 10:36:34:
Yes i have one at the pot works great. I run 1/2 pressure line about 50 ft coil most in the plastic 55 gal barrel i cut in half sure works good even here in Iowa when the RH is high before that i did have a problem with moisture took a gamble on the idea air line is cold going into the pot and as you know is hot coming out of the portable old Jeager 70 cfm with Continetal motor.reg is set on 70 psi have did a ton of tractors and cults ect with the set-up get sand at the sand place that has washed and screened stuff for sand blasting haul three 55 gal barrels weigh in at around 2200 lbs last i got waslike 40 bucks. And i do screen when filling as plugged nozzles aren any fun.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
