For years Red Clover with abit of timothy was all we had for hay for the cows and it was spring seeded over the top in fall sown wheat and the next year you made the hay, you might get a crop of stubble hay the year it was seeded but you may not, for the third year it had died out not enough left to make a crop. And I have never heard of red clover being put on in the fall. As for the notilling that has come about after we quit hay. But all the notill fields I see being put out now you can see are so rough no mater if it is hay, wheat, oats or beans I would not want to be the one driving a tractor over the fields but I also would not want to be using a 100 HP tractor on a hay rake either, 20 to 30 HP is plenty for that job but the rough fields I see you could not stay on the seat on them as you do not have the big enough tires to smoth out the rough spots. Last few years hay was alfalfa spring seeded either over the top in wheet, most common or at the same time as the oats were sown for grain in the spring. No mater the crop we always pulled a cultipacker behind the drill with a spike tooth harrow behind that and always had smooth fields. Never tried fall seding alfalfa but it seams to work here in Ohio either way but August is seeding month, september too late.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
