We used to have those stacks custom made for us. We had mostly corn stalk stacks but we had a few hay stacks too. They weathered pretty well as long as we used them up before the next summer and we did have to store them in a place that was sheltered from the wind. It was a little tough getting the mover under the stack after it had sat awhile especially if the tractor was on frozen ground or snow. Seemed like the tractor (1070 Case and then 1086 IH) didn't have enough traction sometimes to push it back under the stack. The chain would start pulling the stack apart and we still couldn't get backed under it. Hesston did have that crawler track assist under the back that helped a bit but some times the tracks would stall the hydraulics. Toward the end we had a grapple claw on the loader so we could grab chunks of stack and take it to the cattle.
For corn fodder stacks I still think they're OK as long as the stacks can be stored in a sheltered area and a grapple claw of some sort can be used to feed them. I would think if the fodder or hay was tub ground these stacks would work OK if the tub grinder had a claw to grab chunks and feed them into the tub. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
