Posted by Dr. Walt on July 23, 2013 at 05:11:58 from (12.2.223.79):
In Reply to: woodchuck bait posted by tractormiallis on July 22, 2013 at 07:36:13:
Say this 10 times real fast: How much wood would a woodchuck chuck if a woodchuck could chuck wood?
Seriously though, we don't have any woodchucks here in southern Nevada (that I know of), but this works on all other types of rodents and even a Badger, so it may work on a woodchuck.
Thoroughly mix 2 heaping Tablespoons full of Plaster of Paris, with 1 heaping Tablespoon full of Confectioners Powdered Sugar, add this mix to 2 cups of Rolled Oats & thoroughly mix. Place this mix where the critters will find it, but someplace where your Chickens, Cats, Dogs, & other animals that you want to keep can't get into it. The rodents are attracted by the grain, love the taste of the Sugar, and DON'T TASTE the Plaster of Paris which sets up in their stomach's & upper intestines. They can't pass it out & they can't cough it up - works every time.
I've gotten rid of mice, rats, squirrels, rabbits, skunks, & the Badger.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
