DO NOT CUT anything. LOOK at the parts diagram on jdparts. It is on page 14. It is not hard to do technically it may be rusted and not easy but it not hard to figure out.
1) Look at the other end (back) of the horizontal auger. There is a cover about 8-10 inches square. The back bearing bolts to this cover. The cover is bolted to the back of the auger/mixer tube. You remove the four outer bolts that hold the cover to the auger tube. This allows the complete plate, auger and bearing to slide out the back of the auger tube.
2) You need to remove the set screws from the pulleys and sprocket on the front of the horizontal auger. Also loosen the bearing lock collar. The auger shaft slides out the rear of the machine. As you slide it you drop the pulleys and sprockets down in the front.
3) After the auger shaft is out of the bearing you can remove the bolts in the bearing flangets and remove/replace the bearing.
Now is it going to be easy??? Heck NO!!! Everything will be rusted. I drilled a 3/4 inch hole in the cross member that lined up with the auger shaft. I then took a piece if 5/8 bar stock and used it as a punch and drove the shaft out of the sprocket and pulleys.
I cleaned everything up and polished it all up so it slide easy so assembly was not too hard. I also used anti-seize on everything.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
