On a level suface, the oil level should not be above the check plug on the side. It sounds like it was overserviced and possibly still is. I never saw a gearbox on a Rotary Cutter with a drain plug on the bottom. On mine, there is no requirement to ever change the oil. Just check it by removing the small 1/8" side plug and if it needs oil, remove the top 1/2" fill plug and add 90w gear oil until it starts to run out the check plug. I've been running my 6' cutter since 1998 and have never had to add any oil to it. It's still running with the oil from the factory. I've cut 100s and 100s of acres with it. When you tip the mower upside down you're inverting the gearbox, something I've never done. I do the sharpening with it lifted up by the tractor with safety jacks under it. Use a rotary grinder. Replaced the blades once. I find I get a much better cut after the leading edges of the blades have become quite jagged from hitting rocks. Just sharpen the bluntness once in a while. Anyway, if you have a drain plug, why don't you drain it and then refill it to the proper level and then go out and cut. Don't tip it upside down with oil in the gearbox.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors, A Woman's Touch - by Teri Burkholder. I thought I would give you a little background on how I got myself hooked on tractors and their restoration. My family is a very "crafty" bunch of people. By crafty I mean good with crafts!! My Dad is a retired industrial engineer from Bucyrus Erie which made big shovels for excavating and he is also a wonderful wood worker. My mom and my "guardian angel" has had her own ceramic shop for 30 years and is an excellent painter. With these skills always active in our house it was hard not t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
