Posted by ASEguy on June 20, 2013 at 04:45:39 from (68.186.162.134):
I have been helping with the mowing at a local golf course and can tell you I have a whole new respect for people that mow on steep slopes. I have been using a John Deere HST in 4x4 with the fattest rear tires I have ever seen. I swore it felt like it was going to tip, but they said it would slide first. Slid it did for more feet than I like. They "control slide" down some slopes and just said "You'll get used to it." Their other mower is a Toro 4500D in 4x4 and is a beast. It's a five gang mower that I think would stick to an 89 degree slope. When I dream about mowers at night, the Toro is the one. They told me the Toro was a $65,000 mower. I believe them and probably should pay them to cut with it. They also have greens mowers that are reel mowers. They run the blades backwards and use a lapping compound to sharpen them until they will slice off regular paper folded once, and then they set the cutting depth with a dial indicator. Interesting couple of weeks. Be careful. Gerard
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.