A combine, a planter, and a baler a person really needs to own a manual for if at all possible.
Those are such specialty machines, with very complicated settings and adjustments......
So, it was probably good advice, something I might have said.
I understand your frustration, we need to help each other.
But, lot of questions are really hard to explain or know where your skill level is, and on those 3 machines, it just gets tough.
If you have the manual, we can rough in or zero in some help to each other, and know you will be able to follow the small details in the manual.
Without the manual, its a daunting task to put down every step, remind you of the timing issues, go through every adjustment and so on, as one affects another. Put a lot of pressure on a person trying to help, a step done wrong could cost you some dough......
You are kinda asking a lot of people too when you haven't put any effort into knowing your machine, to get a manual on one of the complicated ones.
But I know, when a person wants some simple quick advice, being told to get a book and read is not what a person showed up for!
Hope you get the baler going, didnt notice your message, will have to go look for it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Oil, Oil Filter and Air Breather - by Curtis Von Fange. In the preceding articles we discussed some of the various aspects of doing a comprehensive tune up. Hopefully some light was shed on why we do or don't do certain things pertaining to inspections and order of events when doing a tune up. Perhaps some useful reasons were given for why parts fail and what to do about preventing part failure in the future. All these tips will help us think and reason out a problem in order to make our tune up last and, hopefully, keep us from spending extra mone
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
