About Skunks... back in the summer of 2011 I was in the kitchen fixing lunch when the front room door opened just a bit ( the latch was adjusted just after this !!) I went over to push the door closed and at that moment in walked a skunk! It was a hot summer day and we have a concrete floor that is always cool so he padded around the living room floor while I ran out through the kitchen closing all the doors so he could not get any further into the house. The wife was in her office ( just behind the living room) and she says she heard me say "OH NO, NO, NO, NOOOOOOO" So she came out and through the hallway door (its cut glass) she took this picture of the skunk resting on the living room floor by the edge of the wood stove and our cowhide rug.
He stayed about 10 minutes cooling himself on the floor. I turned on all the lights that I could reach and used a hand held spot light to make things real bright in the living room. He left through the same open door ( without leaving any nasty calling cards for us) I promptly adjusted the front door latch after lunch.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
