Posted by Mike (WA) on May 22, 2013 at 08:56:29 from (69.10.199.42):
In Reply to: Re: Farmall 400 HYD. posted by Janicholson on May 21, 2013 at 20:04:54:
It would be pretty easy to "jury-rig" a setup to try out the live pump to see if it has enough capacity. Take the hoses off one of your implements, connect them to the loader valve, plug 'em in to the remotes, and give it a try. You'll have to tie the control lever for the remotes back so it runs full-time through the loader valve.
If not enough flow, and you have hole for a hand crank at the bottom of the grill, you can get a splined hub to bolt to the crankshaft front pulley, and mount a pump in front of the grill operated by a splined shaft through the crank hole to the front pulley.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
